3.6 causing crash

[fin10]

Hi,

I have today put in V3.6 and since I have done so, whenever I hit a clickspot on a particular panel, FS freezes. I have been using this panel for a year now with earlier versions of FSUIPC and had no problems. To confirm this, I removed all FSUIPC v3.6 stuff out of the modules folder and the panel worked again.

It is a registered version, and I tend not to change anything within FSUIPC so it is a clean install.

Does anyone have any ideas?

cheers

[Pete Dowson]

I have today put in V3.6 and since I have done so, whenever I hit a clickspot on a particular panel, FS freezes.

What is the clickspot supposed to do?

If the folks who programmed the panel are using FSUIPC for something then I could see how that could produce a problem if something were in error, but the only thing I know about like that was related to a gauge called ATN, and the problem was fixed in one of the interim versions available here. Did you check? Please see the Announcements at the top of the Forum.

Regards,

Pete