Jump to content
The simFlight Network Forums

Saitek pro flight yoke, two quads and rudder help

Recommended Posts

Well, you'll need to give a little bit more as to what you've done thus far.

Have you installed the yoke drivers? (Not the SST software. We'll do most configuration via FSUIPC 4.2)

Have you purchased/installed FSUIPC 4.2? You need the registered version.

A recommended approach: Delete your joystick assignments in FSX (except POV). You'll re-assign these with FSUIPC.

Start there and we can go further as needed.

Since you have 2 throttle quads, you have a lot of options available, such as assigning a throttle to each engine (recommended), configuring reverse, etc. Lots of options due to number of axes, but why don't you get the basics going and report back on where you are and what you want to do.


Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.