Saitek throttle quadrant

[Paulvanuf]

Hello,

It is my wish to program aircraft specific the three levers of my Saitek throttle quadrant, using FSUIPC.

1. I managed to programm the throttle lever with a reverse zone.

2. I would like to program the blue lever with the flaps of my jet aircraft (first of all the PMDG NGX). Up is in, steps down the flaps detents.

3. I would like to program the red lever with the spoilers of my jet aircraft (first of all the PMDG NGX). Up is in, first step is arm, further down is fully out (airbrake)

I tried, but didn't succeed.

Is it possible and if 'yes'; How?

Grz.

Paul

[Pete Dowson]

2. I would like to program the blue lever with the flaps of my jet aircraft (first of all the PMDG NGX). Up is in, steps down the flaps detents.

3. I would like to program the red lever with the spoilers of my jet aircraft (first of all the PMDG NGX). Up is in, first step is arm, further down is fully out (airbrake)

I tried, but didn't succeed.

How is it you did not succeed? What did you try?

Is it possible and if 'yes'; How?

For flaps, assign to Flaps, then go to calibration for flaps, calibrate the full range first, then select the detentes option and follow the instructions in the User Guide for setting each detente position.

For spoilers, assign to spoilers, then go to the calibration and calibrate the full range and the 'centre zone' for "arm".

Regards

Pete

[Paulvanuf]

For flaps, assign to Flaps, then go to calibration for flaps, calibrate the full range first, then select the detentes option and follow the instructions in the User Guide for setting each detente position.

For spoilers, assign to spoilers, then go to the calibration and calibrate the full range and the 'centre zone' for "arm".

Thanks Pete,

That little reply did it!

Grz

Paul