To attention Pete

[dejavu1953]

Hi Pete,

Two questions please, i have payware FSUIPC last version.

My questions is about configuration fsuipc with aircraft in this case 737NGX. The first question is if i have configuration but the configuration is not ok and i like to repeat the configuration what i have to do ? go to fsuipc4.ini and delete all part refering the 737NGX and then configurate again or they are other way to do that ?

Last question, i am in dificulty to ghett the best configuration with my saitek throttles can you help me with that please ? The "problem" is when i start to apply throttles they have a "empty zone" initialy and then ghett power very fast and is imposibel to ghett 40% for take off.

I am sorry about my english, i dont know if you understand my throttles configuration problem, if is posibel some help with some kind of tutorial i apreciated, first throttle engine 1 and second throttle engine 2.

thanks and best and happy 2012 to you and family

Luis Serpa

[Pete Dowson]

The first question is if i have configuration but the configuration is not ok and i like to repeat the configuration what i have to do ? go to fsuipc4.ini and delete all part refering the 737NGX and then configurate again or they are other way to do that ?

The quickest and most reliable way is certainly to delete each [....] section in the INI which mentions the aircraft specifically. Otherwise you'd need to delete each and every assignment individually.

Last question, i am in dificulty to ghett the best configuration with my saitek throttles can you help me with that please ? The "problem" is when i start to apply throttles they have a "empty zone" initialy and then ghett power very fast and is imposibel to ghett 40% for take off.

You need to calibrate them properly, following the steps ennumerated in the FSUIPC user guide. If you are assigning in FS, make sure the null zone is minimum (full left) and the sensitivity maximum (full right).

Regards

Pete

[dejavu1953]

The quickest and most reliable way is certainly to delete each [....] section in the INI which mentions the aircraft specifically. Otherwise you'd need to delete each and every assignment individually.

You need to calibrate them properly, following the steps ennumerated in the FSUIPC user guide. If you are assigning in FS, make sure the null zone is minimum (full left) and the sensitivity maximum (full right).

Regards

Pete

Ok Pete i am going to try reconfigurate using the manual user guide.

Thanks for the help, like allways you are very nice person

Luis Serpa