Offsets

[English Rebel]

Okay, I'll apologize in advance for this questions as offsets are Greek to me. I am trying to use offsets that are assigned to JET45 avionics software that apply to the buttons and encoders on the MFD for the Lear45. For instance the first button is assigned Offset 73F8 Size is 1 Bit is 0 and 1 is Pressed and 0 is Released. I can press the button and FSUIPC Buttons and Switches recognizes it and from the drop down list I believe I have to select "Offset Byte Setbits but am anot sure what to enter in the OFFSET and the PARAMETER boxes. Can someone help please? Is the drop down selection correct for this type of offset?

Thanks

Alan

[Andydigital]

Put 73F8 in the offset box and 0 or 1 in the parameter box depending on which way you want your switch to work. I'm no expert on them but from memory I think that is how it is.

[English Rebel]

So the offset box should have this in it -- x73F8 (I'm assuming that because the box contains x0000 then it's telling you to add your 4 digit offset where the 4 zeroes are).

Alan

[Andydigital]

Try it both ways, nothing is irreversable in FSUIPC Alan, I pretty sure its covered in the manual though. As I said I'm no expert, its not something I use very often at all so I am a little rusty in this regard.

[English Rebel]

Okay I just found out that using Offset Byte Setbit requires that the bit (0 in this case) needs to be in binary format. I will retry using binaries instead of decimal.

Thanks

Alan