Rudder trim reset offset needed.

[sxa1376]

Dear Pete,

I want to assign a button to reset the rudder trim. While i saw that you have assignements for rudder trim left and right i can't find the corresponding offset for the rudder trim reset in "0" position.

Best Regards

George Nikolou

[Pete Dowson]

I want to assign a button to reset the rudder trim. While i saw that you have assignements for rudder trim left and right i can't find the corresponding offset for the rudder trim reset in "0" position.

The thread title says you want an "offset". There is an offset for rudder trim position, to which of course you can write 0 to centre it.

But then your text talks about assigning a button instead of writing a program to write to an offset.

Buttons can be assigned to controls, and the control to set the rudder trim postion is,called "RUDDER TRIM SET". did you miss that completely? Just use it to set 0 as the parameter.

Pete