Problem with axis assignment

[Wydawnictwo Mfiles Pl]

In QWSim Avro RJ, spoilers axis has "no spoilers" position at 0 and max spoilers at 16384. However my axis is from -16k to +16k. In result, axis is dead from -16k to 0, and then very short move causes large changes in spoilers.

 

Is it possible in FSUIPC to change or somehow recalculate the input from "-16k->+16k" to "0->+16k", to use all the axis?

 

I can probably do this with LUA, but is it possible without it?

 

Regards,

Slawek

[Pete Dowson]

In QWSim Avro RJ, spoilers axis has "no spoilers" position at 0 and max spoilers at 16384. However my axis is from -16k to +16k. In result, axis is dead from -16k to 0, and then very short move causes large changes in spoilers.

 

All FS spoiler (speedbrake) implementations are like that. It's a feature of FS. Flaps are the same. If you assign and calibrate in FSUIPC it will provide the correct range.

 

Please note when calibrating that the "Arm" position occurs some way off 0 (about 4000 or so). If you are on the ground then, FS will usually immediately set full spoilers, as if after touchdown. So, calibrate in the air, paused or in slew mode.

 

Pete

[Wydawnictwo Mfiles Pl]

Ach, I tried on the ground. Thanks. That will probably solve my problem. :-)

Slawek