P3D V2.5 + Saitek Cessna pro yoke = uncontrollable at low speeds

[efsenable]

Hey guys,

 

New member here.

 

Bought p3d v2.5 and a Saitek Cessna pro yoke the other day.

 

I enjoy it thoroughly, but at low speeds, during approaches, the plane tends to be uncontrollably for me, to a point where each elevator movement (moving side to side is fine) bring the nose up and down in a steep movement..

 

Is there a way to alleviate this very frustrating issue ? would it help if i bought FSUIPC ?

 

Thanks a lot for your reply.

 

Peter.

Edited July 3, 2015 by efsenable

[Pete Dowson]

Is there a way to alleviate this very frustrating issue ?

 

Assuming you aren't flying a stunt or fighter plane, where the controls are intrentionally overy sensitive, then it comes down to proper calibration and adjusting sensitivity.

 

Using FSUIPC, calibrate the controls properly, following the numbered steps in the User Guide, and try one of the "slopes" with the flatter centre areas, which will make the control finer (less sensitive) in the central, normal use, zones.

 

Pete