calibration P3D V3

[Alexis Jeanneau]

Hi all,

 

I've read the topic posted by pete about the calibration but its still not clear to me.

 

As of now, FSUIPC recognizes the axis when i scan it, i'm able to set them, but there is no action in the simulator after calibration :/

 

So i have to use P3D standard calibration which is not very satisfying..

 

Any ideas to help ?

 

thanks 

Alex

[Pete Dowson]

As of now, FSUIPC recognizes the axis when i scan it, i'm able to set them, but there is no action in the simulator after calibration :/

 

Really?  You seem to be on your own. What are you assigning to in FSUIPC?

 

Pete

[Alexis Jeanneau]

Basic things such as elevator or aileron to my saitek yoke..

 

I'll try again to make sure i didn't make any mistake and let you know.

Just a question : Do I have to clear all the axis in the simulator (as in previous p3d versions) or do i have to let them assigned ?

 

thanks

[Pete Dowson]

Basic things such as elevator or aileron to my saitek yoke..

 

Yes, but there are at least 4 ways of doing that. Unless you are specific I cannot really advise.

 

Just a question : Do I have to clear all the axis in the simulator (as in previous p3d versions) or do i have to let them assigned ?

 

 

You weren't forced to do anything in previous versions of P3D because it worked either way. Not currently in V3 though. Please read the pinned thread on the subject at the top of this Forum.

 

Pete