Slope for Flaps

[cachiozza]

Is there a way to adjust the travel on the flaps, ie. "slope" button? When I move the lever of 0 to 5 it takes about 1/2 of the travel and then it is very sensitive after that. Hope that makes sense.

 

[Thomas Richter]

Hi,

 

you might be then better off by using the 'Set up to 10 ranges for action' (Axis Assignment page, on the top right). There you can define up to 10 position of a axis and select below e.g. your flaps offset with the corresponding value, so you can match the needed lever position with the expected flaps position.

I think Pete actually designed it for flaps lever position -> flaps position.

[cachiozza]

Ok Ill give that a try if I can figure it out.