Need Help With Dual CH Throttles That Switch

[tanker55]

Hi: I have a registered version of the most recent FSUIPC module (FSUIPC4.949k) in P3D Vers. 3.2, and I have a problem with dual CH Products Throttle Quadrants.  The problem is that I program one set, but then the quadrants are switched the next time that I start up the program (i.e., the assignments for the right hand quadrant gets switched to the left hand quadrant).  I did some searching for a solution, and I have changed AutoAssignLetters=No to Yes, but the switch keeps happening.  It's more annoying than anything else because I keep having to assign the axises, buttons, et c for the right hand quadrant.  Any suggestions. Mike Gutierrez, North Hollywood, California