Problem Setup joistick logithec extreme 3D pro

[costanzo_roberto]

Hello,

I have problem to my joistich after instal latest version 4.966n, I don't Cannot assign, for the menù Axis Assignement, while seeing the values in the menu Joistck calibration.

Nao i use the assign to my menù for Prepar3D Ver.3.4.1.4 to Pmdg 737ngx

Axis Assignament

Joistick Calibration

Prepar3d setup Axis

you possibile Help me ?

thank,

roberto

 

FSUIPC4.log

Edited May 20, 2017 by costanzo_roberto

[Thomas Richter]

Hi,

please add the following in FSUIPC4.ini [General} section, just as the last lines in that section.

Debug=Please
LogExtras=x200000

Also change here to Yes

[JoyNames]
AutoAssignLetters=Yes

Then run again P3D and wait until fully closed. Please copy and paste the FULL content of your FSUIPC4.ini file and FSUIPC4.log file to your message, please attach the FSUIPC4.JoyScan.csv (found also in Modules folder).

I have here two Logitech Extreme 3D PRO joysticks running, without any trouble.

Thomas

[costanzo_roberto]

13 hours ago, Thomas Richter said:

Hi,

please add the following in FSUIPC4.ini [General} section, just as the last lines in that section.

Debug=Please
LogExtras=x200000

Also change here to Yes

[JoyNames]
AutoAssignLetters=Yes

Then run again P3D and wait until fully closed. Please copy and paste the FULL content of your FSUIPC4.ini file and FSUIPC4.log file to your message, please attach the FSUIPC4.JoyScan.csv (found also in Modules folder).

I have here two Logitech Extreme 3D PRO joysticks running, without any trouble.

Thomas

Hello,

tanks for replay, I resolved the problem, I download FSuipc4 i full Install and registration again, nao running without trouble, my d  the file corrupted the first time to Install.

thanks for help,

Roberto.

Edited May 22, 2017 by costanzo_roberto