EpicInfo PH greater than 128

[Daniel Boulay]

Pete,

have you received any reports on Pigeon Holes greater than 128 not working with epic ISA card...

I have WIN98, Epic card ISA, epicinfo 4.20, FSUIPC 3.10 (not registered yet) and I tried these lines:

DefinePH(133,Test,0,0,0,0)

:Test { }

As you can tell, I did not try to do anything with the value...

I also tried the above lines with PH 129...

Results:

My joystick axis would freeze...some not all...and different result if

i used 129 and 133...

And, after loading it the first time, I would then get an error when compiling my EPL file...wrong version...using eplstrip.exe program.

I would remove these 2 lines and it's fine after.

Since those PH values are for lever positions, could it be that they

only work with the USB version ?

Regards,

Daniel

[Pete Dowson]

Pete,

have you received any reports on Pigeon Holes greater than 128 not working with epic ISA card...

No, but as I am not EPIC support I doubt anyone would send such reports to me. I don't even use EPIC much now -- I do have a USB version connected for a few buttons.

PH's in the range 128 to 255 were'nt supported in any of the earlier firmware versions on the ISA board. I don't know the version number when they were added. You'd need to check with EPIC support.

Sorry,

Pete

[Daniel Boulay]

ok, thanks.

I`ll check with R&R.

Daniel