ELEVATOR SET and RUDDER SET problem

[HATTON]

My FSUIPC version is 4.971.

When I assign either ELEVATOR SET or RUDDER SET function to any particular keyboard key with a parameter of 0, it centers elevator or rudder for only 01 time. Afterwards if I again move elevators or rudder and again tries to center them by pressing the assigned key, it does not works. Then if I again re-assign that same key with a different parameter value then it will move the control surface to that position only once and then again it stops working. Again on re-assigning with parameter 0, it will move the control surface to center but only once. 

Bottom line: it works for only 1 time and then stops.

Kindly find my log file attached herewith.

Regards.

FSUIPC4.log

[Pete Dowson]

12 hours ago, HATTON said:

When I assign either ELEVATOR SET or RUDDER SET function to any particular keyboard key with a parameter of 0, it centers elevator or rudder for only 01 time. Afterwards if I again move elevators or rudder and again tries to center them by pressing the assigned key, it does not works.

What controls are you using for the other ways yo are moving them?  Generally things need to change to be noticed. If the others are using the more usual AXIS ELEVATOR SET and AXIS RUDDER SET controls, then so should your buttons.

Another way, which can be applied to any 'SET' control, is to force the change. Assign it with parameter 1 (say) on Press and 0 on Release.

Pete

 

[HATTON]

Parameter 1 and Parameter 0 did the trick. Thanks.