Button on a client pc via widefs on the flusi-main-pc

[pemartin]

Hello guys!

I have 2 computer. One main with p3d and one client. On this are some arkaze-module connected. 

The arkaze are defined as joysticks-buttons.

When i now press a button connected at the arkaze-module i see at the main-computer (FSUIPC) that there is a button pressed and i can 

define a offset (Offset Byte set) and a parameter (example x78ED and parameter 33 - offset of jeehell-A320).

So all ok. But when i close the p3d and start him again the button definition is gone away.

Did anyone have the same problem.

Best regards

peter

[Thomas Richter]

Hi,

seems the Joystick ID/ registration changed.

Make sure you use in FSUIPC4.ini (or if you use P3Dv4.1 in FSUIPC5.ini) file:

[JoyNames]
AutoAssignLetters=Yes

Also please always send your FSUIPC Log file and if needed like for setting in your case as well your FSUIPC INI file, without there is not much to help with.

Thomas