767300 Posted February 4, 2018 Report Share Posted February 4, 2018 Hello I am having a hell of a time trying to set the flaps detents. I have P3d v3 and the registered version of fsuipc for that. Under the Axis assignment tab I move my lever and it registers. I set it under axis flaps set. Then I jump to joystick calibration. I see my aircraft type ( leveld 767) and 7 detents. I hit the DT tab per the instruction,but when I move my flaps lever none of the numbers move under the set tabs. I have done this successfully before but I cant remember how. Its driving me nuts. I am using a Leo Bodnar board that is calibrated. Danny Link to comment Share on other sites More sharing options...
Thomas Richter Posted February 5, 2018 Report Share Posted February 5, 2018 Hi, best is to show the FSUIPC4.ini file with the saved values and the FSUIPC4.log file. Thomas Link to comment Share on other sites More sharing options...
767300 Posted February 6, 2018 Author Report Share Posted February 6, 2018 Hello Thomas, I think I have a bunk Leo card. I have a new one coming. Let me report back.... Link to comment Share on other sites More sharing options...
767300 Posted February 11, 2018 Author Report Share Posted February 11, 2018 Ok so it was indeed a bunk card. I swapped out for a new one and was able to assign my flaps perfectly. However now I am having difficulty setting up my throttles. They are calibrated in windows fine. So lets say for throttle 2 with reversers on same axis, do I assign to send direct to fsuipc or to fs as noraml axis? Link to comment Share on other sites More sharing options...
767300 Posted February 18, 2018 Author Report Share Posted February 18, 2018 Hello I am now having a new problem. I am now trying to set my ailerons. ALL axis's are deleted in P3d. I have no problem calibrating the ailerons except on the same page when I move them, the Throttle axis moves!!! I allready have my Throttles 1 and 2 set and calibrated. So now When I start a flight my throttles go full when I move my yoke!. Any help would be great. Link to comment Share on other sites More sharing options...
Thomas Richter Posted February 18, 2018 Report Share Posted February 18, 2018 Hi, the problem will "ALL axis's are deleted in P3d.". The reason is that you may have deleted all axes of only one controller, better and suggested is to "Disable Controller" in FS so you don't miss any automatic FS asigned functions. Thomas Link to comment Share on other sites More sharing options...
767300 Posted February 18, 2018 Author Report Share Posted February 18, 2018 I shall try that thanks. Link to comment Share on other sites More sharing options...
767300 Posted February 19, 2018 Author Report Share Posted February 19, 2018 Hi Disabled controllers worked. thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now