FSLabs A320 and flaps

[Blazer2525]

I have assigned flaps increase and decrease incrementally to buttons on my Saitek yoke.  Yet it does not function.  At most I can get from flaps 0 to flaps 1.

I have also assigned the trim and gear to buttons on the yoke and both work.

I have attached my FSUIPC.ini file.

Thoughts/help?

FSUIPC5.ini

[Pete Dowson]

10 hours ago, Blazer2525 said:

I have assigned flaps increase and decrease incrementally to buttons on my Saitek yoke.  Yet it does not function.  At most I can get from flaps 0 to flaps 1.

Do the flaps work fully using the normal P3D default assignments for them?

F5	FLAPS_UP
F6	FLAPS_DECR
F7	FLAPS_INCR
F8	FLAPS_DOWN

If not then check the A320 documentation or FSLabs support for how to operate them. If they only work using the mouse, then you might need to create mouse macros for them instead.

To be sure your assignments are correct 9and theylook ok to me) you can always use FSUIPC's logging -- in this case, enable event logging.

Pete