Ardunio Micro Pro - FSUIPC Axis Calibration?

[JR111]

Hi Pete, John,

I currently use a Saitek throttle unit and have it's calibration stored via FSUIPC, plus assigned ENG 1 + 2 to the 1st lever, followed by ENG 3 + 4 to the 2nd lever.

I'd like to expand and have more levers and came across Kar's 737 design. 

It uses an Ardunio Micro Pro as the I/F card. 

https://www.737diysim.com/build-guides-1/boeing-737-throttle-quadrant-v3 

 

Can you advise if I can still use FSUIPC to calibrate the axis, and assign the ENG's like I do on the Saitek, this time using an Ardunio Micro Pro?

 

Thanks.

Edited January 25, 2021 by JR111
typo

[John Dowson]

43 minutes ago, JR111 said:

Can you advise if I can still use FSUIPC to calibrate the axis, and assign the ENG's like I do on the Saitek, this time using an Ardunio Micro Pro?

It can be used directly if it is seen by windows as a HID joystick type device. If its any other type of HID device, it should be possible via Lua.
Quite a few folks are using Arduino's with FSUIPC, so  I guess it will be ok, but I'm not familiar with the various Arduino models.