Brakes axis not working

[Aman Lulo]

Hi, just installed the last FSUIPC version; trying to set the TM Pedal with the Left and Right axis (after properly rescan after av'ry single action), they doesn't work properly. I tried to set the "control to repeat" option, but as I want to save and exit, this option disappear.

  Did I miss something or made some mistake?

      Thanks for any help & regards,

          Fulvio

PS:Of course no such control is doubled in the sim.

[Pete Dowson]

3 hours ago, Aman Lulo said:

trying to set the TM Pedal with the Left and Right axis (after properly rescan after av'ry single action), they doesn't work properly. I tried to set the "control to repeat" option, but as I want to save and exit, this option disappear.

  Did I miss something or made some mistake

Do those pedals act as AXES, giving variable braking according to how far you press them? If so you should be assigning to the Axis Brakes Left and Right controls in the Axis Assignments, not as Buttons!  You should then calibrate them. You may need to select "rev" to reverse them there, depending on how they behave. You want 0 for no braking and 16000+ for full.  Calibrate with the minimum set a little way pressed to avoid unwanted braking when using the rudder.

If they are recognised as buttons instead then you need to supply more details about what you are assigning to and exactly what you are doing.

Pete

 

[Aman Lulo]

Thanks for your answer; of course I chose the Axis assignement; The only difference is that I didn't calibrate them; I'll try this option.

    regards,

        Fulvio

[Pete Dowson]

9 minutes ago, Aman Lulo said:

Thanks for your answer; of course I chose the Axis assignement

Okay, but your question included "I tried to set the "control to repeat" option" which isn't an option for axis assignment (the left part of the Assignments tab), only for other controls selected for specific ranges within the axis movement (the rather more specialised right-hand part).

Pete

 

[Aman Lulo]

15 hours ago, Pete Dowson said:

Okay, but your question included "I tried to set the "control to repeat" option" which isn't an option for axis assignment (the left part of the Assignments tab), only for other controls selected for specific ranges within the axis movement (the rather more specialised right-hand part).

Pete

 

Fine, got it; this is the reason the repeat option  used to disappear! 🙂