CH Pro Thottle Quadrant, DC6 and FSUPIC

[Peter Clark]

Hi,

This is probably answered but my search-fu is failing me.

I'm trying to set up my throttles in the DC6. I have a CH Pro Throttle Quadrant. I've started the sim, loaded the DC6. Then went into the FSUIPC GUI and mapped the four center axis to throttle 1-4 with send to FSUIPC calibration in the action required. 

Under calibration, I've also got a profile specific set. Under page 3, separate throttles per engine, i can see the throttles move. I pull the throttle all the way back through the detent into 'reverse' and click set on all 4 throttles. then into the detent with a little null zone for 'idle' and full up for 'max'. I see the throttles move in the cockpit, but I can't seem to figure out how to make the idle detent equal idle throttle in the sim. I always have to pull back through the detent to the reverse zone to get the idles to close in the aircraft. Is there some way to map the detent = idle in the sim?

Thanks!

[John Dowson]

Maybe try the *_EX1 throttle controls. See this post: 

 

John