PMDG Offset 6560 (Cabin Climb) goes crazy during taxi

[AtropiN]

Hi!

I connected a servo to cabin climb gauge trough FSUIPC using offset 6560:

6560 4 FLT32 AIR_CabinVSNeedle Value - ft/min

It works fine but during taxiing on ground it goes crazy all 5-20 seconds and goes down to -3000 ft/min and than back to 0.

12333922 7256 Monitor IPC:6560 (FLT32) = 0.0010
12334391 7256 Monitor IPC:6560 (FLT32) = -0.0102
12336688 7256 Monitor IPC:6560 (FLT32) = -2891.6968
12336984 7256 Monitor IPC:6560 (FLT32) = -2891.6965
12337141 7256 Monitor IPC:6560 (FLT32) = -0.0102

Did i miss something ? 

Kind Regards

Ilja Smolnikov

[John Dowson]

The PMDG offsets are just populated directly from the data received from the PMDG SDK. If there are any questions or issues with this data, you need to ask about this (i.e. SDK variable AIR_CabinVSNeedle) on the PMDG support forums.

Sorry I can't be of more help,

John

[AtropiN]

Thank you, thats what i thought but i got this reply from PMDG 🤪:

Quote

As this is an FSUIPC offset and not our own I would suggest to check with FSUIPC creator about that.

I will try and add 0x0366  to my script (if its working in with MSFS) to supress any needle movement on the ground  

 

Edited November 18, 2022 by AtropiN

[John Dowson]

51 minutes ago, AtropiN said:

Thank you, thats what i thought but i got this reply from PMDG 🤪:

Quote

As this is an FSUIPC offset and not our own I would suggest to check with FSUIPC creator about that.

That is probably because you asked about an FSUIPC offset - you should just ask about the SDK variable. As I said, FSUIPC just populates the offset with the value received.

52 minutes ago, AtropiN said:

I will try and add 0x0366  to my script (if its working in with MSFS) to supress any needle movement on the ground  

That is also an option!

Cheers,

John

[AtropiN]

Thank you John, i will contact them again about SDK variable and meanwhile use 0x0366 👍