issue FSUIPC 7 affecting PMDG 777-300ER Climb performance

[brunorrr]

Hello there, I hope you all are doing fine.

I'm finding some issues during the climb phase of PMDG B77W for MSFS. After some testing and reading, I found out that what's causing the issue is the FSUIPC 7 itself.

I think this video can clarify what I mean. It was recorded before I try to turn FSUIPC off.

After this recording, the plane managed to climb up to FL270, then I close FSUIPC and it starts climb normally up to FL320 just like it should be. After leveling at cruise level, I turn FSUIPC 7 on again and resume the flight normally.

 

Topic discussing this issue in PMDG's forum

Thank you all.

[John Dowson]

This issue is usually caused by flaps calibration. If flaps assigned in FSUIPC, make sure it is assigned with 'Direct to FSUIPC calibration'. If not assigned in FSUIPC, check that you are not post calibrating. You can attach your FSUIPC7.log and FSUIPC7.ini files and I can take a look.