FSIUPC 7 not working anymore

[lolo97410]

Dear Sir

since I upgrade FSIUPC the software does not seem to work anymore

The presets do not appear anymore and the hvar files in the fsuipc-lvar-module

in the community folder are not read anymore even if the folder is in the community folder

English is not my mother tongue and I am experiencing difficulties reading the previous posts

I remember having the same issue a LONG time ago and you helped me 

I enclosed the FSIUPC log file and InstallFSUIPC7 

There is no log file in the fsuipc-lvar-module ???? 

Please I would be greatly obliged if you could help

Greetings from Reunion Island French overseas territory Indian Ocean

Bonnes Fêtes à vous !!!!

FSUIPC7.log InstallFSUIPC7.log

[lolo97410]

I am flying with MFS2020

[lolo97410]

hello 

went to the old post I made with you

[General]
DetectToConnectDelayAuto=400
 

put that line the fsiupc as you previously mentionned

and everuthing is working fine again

sorry for the disturbance

Merci 

[John Dowson]

19 hours ago, lolo97410 said:

went to the old post I made with you

[General]
DetectToConnectDelayAuto=400

That may be ok or could be too high. You should either tune that parameter or let FSUIPC tune this for you. See the section Auto-tuning of initial start-up ini parameters in the Advanced User guide, Also, from the User Manual on page 7:

Quote

IMPORTANT – please read!!!

Although FSUIPC7 should run reasonably well without any manual configuration, there can be connection issues if you have a slow start-up time (i.e. the time taken between starting MSFS and arriving at the main menu), usually due to having a lot of add-ons installed in your Community folder. Since FSUIPC7 version 7.4.12, FSUIPC7 will monitor for any such issues and adjust some start-up parameters appropriately. This parameters will take affect the next time FSUIPC7 is auto-started and you do not need to take any action. However, if you have a very long start-up time (i.e. time taken from starting MSFS to it arriving in the main menu takes longer than 5 minutes or so) then it may be a good idea to restart MSFS for these new parameters to take affect.

More on auto-tuning can e found in the Advanced User manual. It is also possible to manually set these parameters – see the following FAQ entry on how to do this:

https://forum.simflight.com/topic/98307-fsuipc7-configuring-connection-parameters-for-optimal-use-and-to-preventsimconnect-issu