Question regarding Fenix A320 LVARS

[Mark van Wissen]

*** Moved to FSUIPC7 support sub-forum ***

Hi,

I am trying to get FenixQuartz to show COM values on my StreamDeck+. Now, I noticed that lvars "FNX2PLD_com1Active", "FNX2PLD_com1Standby", "FNX2PLD_com2Active" and "FNX2PLD_com2Standby" are all set to 0.000000, when running MSFS2024. In MSFS2020, they are all set and I can see the respective frequencies on my StreamDeck+. What am I missing? Thanks for your help.

Regards,
Mark

Edited February 11 by John Dowson
Moved to FSUIPC7 support forum

[John Dowson]

Please use the FSUIPC7 support sub-forum for all issues and questions for FSUIPC7 - I have moved your post.

31 minutes ago, Mark van Wissen said:

Now, I noticed that lvars "FNX2PLD_com1Active", "FNX2PLD_com1Standby", "FNX2PLD_com2Active" and "FNX2PLD_com2Standby" are all set to 0.000000, when running MSFS2024. In MSFS2020, they are all set and I can see the respective frequencies on my StreamDeck+. What am I missing?

Do you see any values in other lvars? Can you set/change the value of an lvar (via Add-ons->WASM->Set Lvar)?

Check to see if the WASM has crashed in MSFS2024. It seems that the WASM crash is more frequent in MSFS2024. if the WASM is crashing and you have not disabled lvar scanning, please do that.

If the WASM isn't crashing and the lvar values are being received by FSUIPC, then that must be the value of the lvars.
I don't have the FenixQuaerz so cannot check this here, sorry.

John

[Mark van Wissen]

Hi John,

Thanks for your help :-)! I was finally able to resolve my issue. I found a completely different way without FenixQuartz.

Thanks and kind regards,
Mark