Automated Throttle 737

[Lam]

Hello, 

I automated a throttle by adding two 12V DC motors via an FDBUS card. I declared the output command values as 0x9002 ( 16U) and 0x9006(16U) in Prosim737.
When I launch FS2020, I look at the FSUIPC log and see that my values 9002 and 9006 remain at zero even though I move the throttle levers.

before I used FSUIPC 5.134 with FS2020 (I think) and it worked but not anymore.

before I used win10 and now win11.

I checked the firmware and updated VC++ but nothing changes, the values remain at zero

Question :

The variable  9002 and 9006  are used for something else ?

Any idea ?

 

Thanks in advance

Lamine

[John Dowson]

15 minutes ago, Lam said:

before I used FSUIPC 5.134 with FS2020 (I think) and it worked but not anymore.

FSUIPC5 is for P3Dv4 only, not FS2020. Only FSUIPC7 works with MSFS2020.

17 minutes ago, Lam said:

I declared the output command values as 0x9002 ( 16U) and 0x9006(16U) in Prosim737.
When I launch FS2020, I look at the FSUIPC log and see that my values 9002 and 9006 remain at zero even though I move the throttle levers.
...

Question :

The variable  9002 and 9006  are used for something else ?

Do you mean offsets 0x9002 and 0x9006?
Those offsets are not (and never have been) used by FSUIPC itself. Looking at the code, offset area 0x9000 - 0x93FF has been allocated to "Nico Kaan for Lekseecon(Level D 767, 757)".
I have no idea who this is or what these offsets are supposed to do - they were allocated way before my time. All I can tell you is that they are not used at all by FSUIPC.

John