Assignment for the Flight1 Citation Mustang “Master Warning” button

[John Dowson]

Note also that there were no profile-specific button assignments in your FSUIPC6.ini, and the general assignments only contain one button assigned to Pan Down.
Controllers are also set to On in P3D, so you seem to have almost all of your assignments in P3D, not in FSUIPC.

If you send / post any further logs, please disable logging for Events (non-axis controls) and Axis controls and set logging for Buttons & Keys instead.

John

[GiankMustang]

 [QUOTE John] Why don't you try this?

I tried, and I have to say... you were right. I finally tested the entire “LuaSet F1MustangSwCtl.lua” package, which is a big step forward compared to Mustang Flight1, however I found some obstacles: 

1- THROTTLE CUTOFF. To turn off an engine, I set the Throttle to CUTOFF, but the engine does NOT turn off, the rpm go to minimum in IDLE but do not go to zero, in fact FUELBOOST does not turn off on the CAS-MSG. To turn off the engine I should act on DISENGAGE, but it is a subterfuge because this only cuts the electrical power, while CUTOFF cuts the fuel. 

2- STBY-AVIONICS and ENGINE-SYNC. I could not make them work in any way, so I programmed them with Mouse Macros. 

3- The START Buttons do not light up while they are working. These incorrect behaviors do not exist in the Mustang F1, nor in the Mustang True. My friend and consultant, who is a true pilot of true Mustang, confirms this to me. 

Do you have a solution to these Problems again? 

Thanks again. 

Giancarlo.

[GiankMustang]

[QUOTE John] You have asked this before. 

Sorry, I forgot.