C.Schaffhausen

Thanks John, I'll try that!

Hello, does anyone know how to program a switch to operate the transponder (STBY, ALT RPTG OFF, XPDR, TA, TARA)? Much appreciated.

Not sure what you're referring to, but the goal of my setup here is that I can go from idle to idle reverse, idle reverse to max reverse, max reverse back to idle reverse, and from idle reverse back to idle. I think this works to a certain degree, would love to know how could I improve this so it is more stable!

This is what I use: [Buttons.PMDG 737] 1=PC,9,C65966,1 -{THROTTLE1_DECR}- 2=UC,9,C65967,0 -{THROTTLE1_CUT}- 3=RC,25,C65966,0 -{THROTTLE1_DECR}- 4=UC,25,C65965,23 -{THROTTLE1_INCR_SMALL}- 5=PC,10,C65971,1 -{THROTTLE2_DECR}- 6=UC,10,C65972,0 -{THROTTLE2_CUT}- 7=RC,26,C65971,0 -{THROTTLE2_DECR}- 8=UC,26,C65970,23 -{THROTTLE2_INCR_SMALL}-

Hello all, Is it possible to program a switch so when it is on, the throttle outout is limited to a certain percentage (let's say 90%) even though the physical throttle is maxed out? Thank you all! Best regards, C.Schaffhausen

Hello, I came up with something to make the following work on Honeycomb bravo reverse with the PMDG 737: 1. Idle Reverse when using the reverse lever 2. Full reverse when pulled into the reverse detent 3. Resume Idle Reverse (more or less) when throttle moves away from the detent 4. Disable idle reverse when the reverse lever returns to normal position Reverse Switch: When pressed: Throttle1 Decr Parameter 1 When released: Throttle1 Cut Parameter 0 Reverse Detent: When pressed: Throttle1 Decr Parameter 0 (Repeat when held) When released: Throttle1 Incr Small Parameter 23 Same setting applies for throttle 2, let me know if it works for you, thank you!

Hello John, any updates?