AW1312

Hello all When starting FS the ailerons are 'stuck' in the operational postion and I have to move the yoke back and forth several times in order to get them to move. I have tried re calibration and this does appear to work for a while after which it returns to the same state. Any help would be appreciated. Alan W

Hello again. Right I've had another go and I think I have have now resolved the issue! Can I take this opportunity to ask for some advice regarding the ailerons? When I start my flight the ailerons are always 'stuck' in the bank position. It takes a few turns on the yoke to get them to move. I can't figure out what is causing it. Thank you Regards Alan W

Hello Peter Thanks for your reply. I hope you had a good trip? Ok. I have tried to calibrate again but still no luck. I tried the way you suggested min & max before the DT button. I have positioned the lever just outside flaps up and flap 40. Interestingly it was flap 40 that I could not calibrate before now that isn't an issue. I have tried all the permuatations following the instructions in the manual to the letter. I noted that moving the lever from flaps 0 that the values don't change until the lever is sitting in the flap one notch. So I assumed that if there is no value change then the flaps will not retract? I hope thats enough to go on ? Thank You Alan W

Hello all Firstly; I'm using FS9, with PMDG 800/900 and up to date FSUIPC. The flaps decided to de-assign themselves in FSUIPC! How is this possible? And I have been attempting to re-calibrate and have been succesful except I cannot calibrate flaps up. I can set the range from 0-40 but when I move the flaps lever to set flaps 0 in the calibration window the values don't increase until the lever reaches the flap one position making it impossible to set flap 0!! Is this a hardware issue perhaps? After take off and selecting flaps up I have found that if I move the flaps lever back and forth several times then the flaps will retract fully. I have the reolution sim products TQ. I also hope this makes sense!!!! Thank you in advance AW