I have a registered copy of FSUIPC 3.411, and I have the CH Yoke, Pedals and Throttle (all USB). Downloaded it tonight. I am attempting to get reverse thrust working, by using the mixture axis.
I started off by configuring the mixture axis. I am using the leftmost axis on the CH Yoke. I move it fully forward to set maximum; and all the way back to set minimum. My min value is -16193, my max is 16192. As I move the lever back and forth I see the OUT values go from -16384 to 16384. All looks good thus far.
I then go to page 7 to calibrate the reverser using the mixture. I click SET for the reverser. Currently IN =-16193, OUT=0. Since the lever is all the way back (ie. no reverse) I click the SET button under idle, and the Idle value becomes -16193. I then move the lever full forward for reverse and the IN value goes to 16192, but the OUT value stays at 0. If I try and click SET under Reverse I just get a ding and it refuses to take.
I know reverse works because I can hit F2 and watch the buckets deploy.
I have looked through the manual and tried this numerous times over the past few days/weeks and have not gotten it to work. I am obviously missing something basic but I don't know what it is.
Cheers!
Luke
I have a registered copy of FSUIPC 3.411, and I have the CH Yoke, Pedals and Throttle (all USB). Downloaded it tonight. I am attempting to get reverse thrust working, by using the mixture axis. I started off by configuring the mixture axis. I am using the leftmost axis on the CH Yoke. I move it fully forward to set maximum; and all the way back to set minimum. My min value is -16193, my max is 16192. As I move the lever back and forth I see the OUT values go from -16384 to 16384. All looks good thus far. I then go to page 7 to calibrate the reverser using the mixture. I click SET for the reverser. Currently IN =-16193, OUT=0. Since the lever is all the way back (ie. no reverse) I click the SET button under idle, and the Idle value becomes -16193. I then move the lever full forward for reverse and the IN value goes to 16192, but the OUT value stays at 0. If I try and click SET under Reverse I just get a ding and it refuses to take. I know reverse works because I can hit F2 and watch the buckets deploy. I have looked through the manual and tried this numerous times over the past few days/weeks and have not gotten it to work. I am obviously missing something basic but I don't know what it is. Cheers! Luke