Condition leveler

[werver]

Dear Pete,

For my Flight1 Cessna 441 I want to assign leveler 2 of my CHProducts yoke to the two Condition levelers of the (turboprop) airplane. I have leveler 1 assigned to the trottles and leveler 3 to the reverser, which are working ok. In FS2004 I have leveler 2 assigned to the prop.

Is this possible to use leveler 2 for the condition leveler, and of course how?

[Pete Dowson]

In FS2004 I have leveler 2 assigned to the prop.

Is this possible to use leveler 2 for the condition leveler, and of course how?

In FS the "condition" levers are the same as the "mixture" levers. Just use FS's Options-Controls-Assignments to assign your lever to the mixture axis.

However, if you are using FSUIPC's jet reverser to get reverse thrust on a jet, remember to check the option on that FSUIPC page to have it only operating for jets. By default the FSUIPC jet reverser uses the mixture axis. You'd have to use the same lever for both, and what it does would then depend on the aircraft you have loaded.

Regards,

Pete