"Y-Rotation" axis not read since Update to FSUIPC

[HPR]

Dear Pete

First of all (though very late :oops: ) thank you for this GREAT utility!

Then the evil hammer :twisted:

Today, I upgraded to 3.45 and I'm quite sure since then I can't set the engine#1 mixture anymore.

I'm using CH Products Throttle quadrant, USB type

Setup:

ThrottleL ThrottleR PropL PropR MixL MixR

X-Axis Y-Axis Z-Axis X.Rot Y-Rot Z-Rot respectively

The readout of Y-Rotation axis remains 0 in the Joystick (what was it? Page 3or4?) tab of fsuipc

When checking in the system settings, all levels are ok and move.

The FS's Joystick assignments which I checked also were correct

I re-installed FSUIPC V. 3.4.0 (which I fortunately (?) kept - same behaviour. So I'm not even sure anymore that this is a problem with the new version :shock:

And now, I am at a loss..

Edit: More at a loss: I renamed fsuipc.dll, so it's not loaded anymore. AND I still have the same problem. But it is not yours anymore... Which-to be honest- I'm not sure makes me happier or not :roll: :lol:

Though I'm too old to cry "emergency-help immediately" I'd appreciate a hint in the next few days, as I'm off(-line) Feb12-20. Though it's no catastrophe if you're able to help me after that.

If you need further infos, of course, feel free...

Thanks and best regards from LFSB,

HP.

[Pete Dowson]

Edit: More at a loss: I renamed fsuipc.dll, so it's not loaded anymore.

Safer to move it out of the Modules folder. If you rename it be sure to omit the "dll" part.

AND I still have the same problem.

Did you check the sensitivity setting in FS? For some reason it seems to occasionally reset sensitivities to zero -- that gives exactly the symptoms you describe. There's nothing else I can think of.

Regards,

Pete

[HPR]

Good morning Pete

:shock: I didn't know you offer 24/7 support :D

Safer to move it out of the Modules folder. If you rename it be sure to omit the "dll" part.

fsuipc.dll.345 and *.340 8)

Did you check the sensitivity setting in FS?

No, I never checked those (assuming default settings would do)

--> till I saw WHAT settings there were :evil:

All those strange things I've tried to compensate within fsuipc engine settings :?

Among - as you suggested - the sensivity of mixture 1 on zero.

Bottom line:

Problem solved, issue closed.

And another happy customer 8)

Thanks very much indeed for your fast and efficient help!!

Best regards,

Hanspeter