Trying to setup ADF2

[OAL331]

Hi,

i have Fsbus system (hardware & software) and i use it to read & write in Fsuipc offsets for Fs2004 & PM.

So, i made my pedestal and trying to setup the ADF2 i found that even if i was using the correct offset (02d4) i was receiving the ADF1 freq.

I tryed to declare the ADF2 in the same way as Dirk has the ADF1 in std FsBus setup.

I know that there are 2 offsets for ADFs, if there is not Fs or Fsuipc problem maybe there is something wrong in Fsbus.

I'm just asking if anyone else had the same problem, or if the ADF2 is not working 100%.

Thanks

Eddie Armaos

Athens - Greece

[Pete Dowson]

I'm just asking if anyone else had the same problem, or if the ADF2 is not working 100%.

The second ADF is only provided in FS2004, and then only if it is implemented in the Aircraft you are using. Check your Aircraft.CFG file and see if it has one or two ADFs.

Pete

[OAL331]

Thanks Pete,

i will do, but i beleive it supports the dual ADFS as it was the PMDG's 737-600.

I will also try to read the offset 02d4 from PM'sCDU, if it will be ok there, maybe the problem is on Fsbus side.

Eddie

[Pete Dowson]

I will also try to read the offset 02d4 from PM'sCDU, if it will be ok there, maybe the problem is on Fsbus side.

The easiest way to see any offset is to use FSUIPC's Monitor -- see the right-hand side of the Logging options page. Add 02D4 as type U16 and check the Hex option, then check the "AdvDisplay" option below to see it in real time on screen.

BTW, I've just tried it on the PMDG 737-600 cockpit and it is all working fine.

Regards,

Pete

[OAL331]

Yes both FS2004 and Fsuipc work ok.

I have monitoring the offset 02d4 in AdvDisplay with correct values, but Fsbus does not display it.

thanks Pete, i have to loock in Fsbus the solution.

Eddie