RoughLandings Posted January 8, 2006 Report Posted January 8, 2006 Ok, first post for me in this forum. I am a long time owner of FSUIPC, but haven't had a whole lot of need to use it much till now. I just purchased the CH Products throttle quadrant and for the most part everything has gone smoothly in setting it up. I have successfully set up all the axis' using the Control Manager and calibrated them in FSUIPC. The only thing that I can't seem to iron out is the throttle calibration. If I set them up to include reversers, I have a dead zone through about the first quarter to third of the lever travel. I am pretty sure that I saw a post somewhere in the forums about this issue earlier when I was going through the initial setup, but I'll be dinged if I can't find it now. So I am sorry if I am bringing up a subject that has already been addressed.
Pete Dowson Posted January 8, 2006 Report Posted January 8, 2006 The only thing that I can't seem to iron out is the throttle calibration. If I set them up to include reversers, I have a dead zone through about the first quarter to third of the lever travel. I think Bob "Sticky" Church has written all this up someplace. Try CMNote02.zip on http://www.stickworks.com, or visit http://www.ch-hangar.com. Regards, Pete
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now