a little help please

[visualbyte]

i have purchased fsuipc and widefs i have these set up and running with fs commander on pc 2 but on pc 3 i would like to put all the gauges and controls could some one assist me in how i go about this please also pete fine job the intallation was seemless and caused no problems at all and thus far i am chuffed to bits. my wife is not cheers for any help

jc

[Pete Dowson]

i have purchased fsuipc and widefs i have these set up and running with fs commander on pc 2 but on pc 3 i would like to put all the gauges and controls could some one assist me in how i go about this please

What programs are you using for these gauges and controls? If they are all FSUIPC-interfacing programs all yuo should need to do is to run them on the client when Wideclient is running. In fact you can get WideClient to load them for you using the "Run" or, better, "RunIf" parameters in its INI.

If you are referring to FS's own panel gauges then these are part of FS. They are not FSUIPC programs and cannot be run outside of FS. They aren't even separate programs, "GAU" files are not a lot more than sets of instructions for driving FS graphics.

I'm not sure where this "fs commander" comes into the equation.

Regards,

Pete

[visualbyte]

well i may of put my question wrong as what i am trying to find out is.

what programs are there to run the gauges sepratly on another machine cheers for the reply

jc

[Pete Dowson]

what programs are there to run the gauges sepratly on another machine

The main one, the one I use, is Project Magenta. But it isn't cheap. It boasts the most complete set for airliners, and there is also a set for GA aircraft. See http://www.projectmagenta.com.

There used to be a freeware set called FeeFDS, but I've not seen that available for a while. Don't know why.

There's a freeware reduced function FMC+ND called "vasFMC" by Alexander Wemmer, which is quite handy -- http://vas-project.org.

You could try checking through the partial list of FSUIPC-compatible programs on the http://www.schiratti.com/dowson page. Other that that, I suppose browsing the Forums or Googling might uncover something.

Regards,

Pete

[rickalty]

What sort of aircraft do you fly?

If GA, there's my FSPanel available for free download in the AVSIM file library.

Richard