how to program the buttons of Cirrus jetliner joke with FSU

[mvc340]

I go to FSUIPC and i select the asign button .

i push the button, and FSUIPC recognices it

then i select thein the list of fs2004 actions the forsware view

but then in fs2004 when i push the button there is not the correct answer

I talk about the 4 buttons in the right of the yoke

[Pete Dowson]

I go to FSUIPC and i select the asign button .

i push the button, and FSUIPC recognices it

then i select thein the list of fs2004 actions the forsware view

but then in fs2004 when i push the button there is not the correct answer

Sorry, I need more information. Did you confirm the assignment (not exit by closing or ESCaping)?

I would need to see your FSUIPC.INI file. I also need to know what you actually mean by "forsware view". Do you mean "forward view"? If so, in order for that to change anything you need to have previously selected a different view.

I talk about the 4 buttons in the right of the yoke

Sorry I don't know CH hardware. But the location of buttons is not relevant. If they are seen by FSUIPC and you assigned them, they will be doing what you assigned them to do.

Regards

Pete

[mvc340]

sorry

yes it was forward view

It´s not CH, its PFC cirrus jet yoke.

[Pete Dowson]

yes it was forward view

It´s not CH, its PFC cirrus jet yoke.

Ah sorrydidn't read it properly.

Connected direct to the PC, not via one of the control systems (and thence via my PFC driver)?

What do you expect to happen when you press "forward view"? Normally you would use the buttons to select anything but the forward view when pressed, then view reset when released. Can you tell me what you are trying to do, and please show me the INI file, the [buttons] section.

Regards

Pete