Landing Gear Control Via FSUIPC

[flouid]

Hello,

I´m trying to make a program that simulates gear extension failure.

Lets say I need to avoid, via FSUIPC, that RIGHT MAIN GEAR locks down (simulating a gear problem).

Tried to write on FS9, via FSUIPC, the 0BF0 address, using FSUIPC_Write, but Im not getting any success.

Is this address read only? Is there a way to make the above mentioned failure? If yes, how?

Thanks in advance.

Roger

[Pete Dowson]

Tried to write on FS9, via FSUIPC, the 0BF0 address, using FSUIPC_Write, but Im not getting any success. Is this address read only?

The three separate gear positons are read-outs. You can write to them, but FS will simply overwrite them with the next value.

Is there a way to make the above mentioned failure? If yes, how?

I don't know any way of making a partial failure. There is a facility in FSUIPC for preventing the gear being raised or lowered, that's all. See offset 32F8.

Regards

Pete

[flouid]

Thanks Pete.

You´re really fast to post an answer :D

Hope someone knows a way to do it, if possible.

Thanks again.