Saitek Yoke and quadrent programing

[RDG41]

Hi all,

I'm nearly at the end of my rope :cry: trying to figure out how to program the Saitek Pro yoke with and extra quadrent using FSUIPC.

I can get all (4) throttles programed ok,(except rev thrust) but because the first (2) levers on the second quadrent have a default assignment for ailerons and elevator ,they still control these assignments along with the throttles. So when I move the throttles for engines 3 and 4 , the yoke is also moving in the sim as well.

I'm sure this is just something I'm doing wrong but I've tried everything. I've deleted all the assignments in FSX and I still can't seem to get rid of this.

If someone could guide me through programming this for the PMDG 747,or could make a small tutorial, I would be so grateful and I'm sure it would help alot of other not so "techi" people out there.

Thanks for the help, Ron Gautreau

[Pete Dowson]

... because the first (2) levers on the second quadrent have a default assignment for ailerons and elevator ,they still control these assignments along with the throttles. So when I move the throttles for engines 3 and 4 , the yoke is also moving in the sim as well.

Why not simply delete those assignments in FS's dialogues?

I've deleted all the assignments in FSX and I still can't seem to get rid of this.

Surely not? How can they still operate if deleted? Are you sure you are looking at the right device -- don't forget FS only shows one device (one set of assignments) at a time. You need to select each device in turn in its drop-down and check.

Regards

Pete

[RDG41]

Hi Pete,

Thanks for the quick response. As it turns out, you were right about divices :oops: When I went through all of them, it seems I missed one. Once this was deleted , all was well :D .Thanks for the help.

Ron Gautreau