CH Eclipse Yoke 3 Position Selector Switch

[dux105]

Hi

Can I have a step by step guide on how to program the 3 position selector switch on the CH Eclipse Yoke so that I can utilise the full 240 functions.

Perhaps with an example.

I have read the FSUIPC4 for advanced users but I'm afraid it is a bit above me.

Hope someone can help.

dux105

[Pete Dowson]

Can I have a step by step guide on how to program the 3 position selector switch on the CH Eclipse Yoke so that I can utilise the full 240 functions.

240 functions with a 3-position selector? does it have 80 other buttons, then, to give 3 x 80?

It sounds like you need the documentation for the device itself, or possibly its own CH software?

I have read the FSUIPC4 for advanced users but I'm afraid it is a bit above me.

I'm not sure why that would come into it in any case.

Regards

Pete

[Bob Church]

Hi dux105,

Pete's right, you need to run the CH Control Manager and use it in Mapped Mode. It can be used to select 1 of 3 Modes, when you multiply the number of available controls by 3 and then double it again using a Shifted set of command, you can get up to 240 functions. Without the CM running, it just shows up as three button. They're maintained, not momentary, so if you use all of them you probably want to set FS to not repeat, or just use the left and right position for something like "Start" and then return it to center. The maintained button can be problematic in some situations.

Hope this helps clarify things.

Best regards,

- Bob

The StickWorks

http://www.stickworks.com