Reverse thrust detant and aft show no numbers

[timtaylor1]

H. I am trying to calibrate reverse thrust. when I move the handle from full forward to idle there is a number change. when I pull the throttle into where reversers are there is no number registering. (a dead zone) any way of wiping out the memory in FSUIPC as far as the throttle quadrent is concerned so I can start over again?

Thanks Tim

[Ian P]

What type of throttle quad are you using, Tim?

If it is a Saitek quad, then the "reverse" arc is actually only a button, not moving on the potentiometer, so the numbers won't change when you are in that area.

In direct answer to your question, just calibrating the device again using FSUIPC will clear the settings you have already stored.

Ian P.