FSUIPC Beeping when trying to cinfigure Saitek Yoke

[LeeL]

Hi

I just got my pro flight yoke system earlier this week. Everything has been working fine. But yesterday I went to try and configure a plane using FSUIPC just like I had been doing, but now after I've done the axis assignment page and when I move over to the joystick calibration page and try to configure the aileron movement it beeps every time I hit set. It doesnt happen with any other axis just the aileron. It's happened to two planes now. please help.

thanks Lee

[Pete Dowson]

I just got my pro flight yoke system earlier this week. Everything has been working fine. But yesterday I went to try and configure a plane using FSUIPC just like I had been doing, but now after I've done the axis assignment page and when I move over to the joystick calibration page and try to configure the aileron movement it beeps every time I hit set. It doesnt happen with any other axis just the aileron.

"Beeping" only occurs when you try to set lower numbers above higher ones, or vice versa. The numbers in calibration must go from low to high, left to right -- also bearing in mind that negative numbers are lower than positive ones. You are probably getting confused by your left/right turning action on the aileron, which is not the same thing. FSUIPC's calibration is always numerical -- that's why it is also precise.

Pete

[LeeL]

Hi Pete now I feel a bit stupid :D but thanks for the help and the great program!

Lee