Button Bug in FSUIPC v3.998K ?

[graemeb]

I recently downloaded the V3.998K version of the FSUIPC module, and copied it into my FS9\Modules folder. I immediately discovered a problem with my CH Yoke elevator trim buttons, which I have defined in FSUIPC (see attached screenshots). The Trim Up button worked as usual, but when I pressed the Trim Down button, the elevator trim went immediately to maximum UP, and the plane started to climb dramatically. I tested this several times, then quit FS9 and replaced the module with older version v3.998h, and everything has gone back to normal.

I hope my post is clear? Let me know if you need more details.

Regards,

Graeme

[Pete Dowson]

I recently downloaded the V3.998K version of the FSUIPC module, and copied it into my FS9\Modules folder. I immediately discovered a problem with my CH Yoke elevator trim buttons, which I have defined in FSUIPC (see attached screenshots). The Trim Up button worked as usual, but when I pressed the Trim Down button, the elevator trim went immediately to maximum UP, and the plane started to climb dramatically. I tested this several times, then quit FS9 and replaced the module with older version v3.998h, and everything has gone back to normal.

Thanks. I spotted that the other day, but I was part way through some other changes so couldn't replace the upload. It'll be okay in 3.998m, probably tomorrow or late tonight.

Regards

Pete

[graemeb]

Good news - thanks Peter.