rotory encoder to slow

[razie1]

Hi all,

I recently built a mjoy16 controller and im usiing a rotary encoder as a trim wheel.

My problem is that it is to slow so im woundering if there is away to speed this up?

Thanks in advance,

Mike.

[Pete Dowson]

I recently built a mjoy16 controller and im usiing a rotary encoder as a trim wheel.

My problem is that it is to slow so im woundering if there is away to speed this up?

1. Assign to both "press" and "release" -- most encoders send an on and off alternately. That would double your speed.

2. Use Offset Inc/Dec controls instead of the FS trim controls. See the example in the FSUIPC User Guide (the boxed section entitled "Offset Increment/Decrement Controls") which is actually the very thing you want and allows you to make it completely adjustable to your liking.

Pete

[razie1]

I must of missed that section of the manual.

many thanks for pointing me in the right direction it worked perfectly :)

Mike

Edited November 16, 2012 by razie1