P3D v3.3.5.17625

[robvanderwiele]

Hello Pete,

Just did a reinstall of the latest P3D v3.3.5.17625 and when I installed Fsuipc it gave me a warning that this version isn't supported. But did install. I used version 4.955.

 

Regards,

Rob van der Wiele

 

[Thomas Börjesson]

Same here and now P3D shuts down during the startprocess.

Regards

Thomas Börjesson

ESNN

 

[Pete Dowson]

4 hours ago, robvanderwiele said:

Just did a reinstall of the latest P3D v3.3.5.17625 and when I installed Fsuipc it gave me a warning that this version isn't supported. But did install. I used version 4.955.

Yes, 4.955 is okay for 3.3.5. The installer doesn't recognise the build number, but it is only a warning. It wasn't worth a complete re-build for this update and most folks won't need to reinstall FSUIPC in any case. Why did you? You shouldn't delete the Modules folder just to update P3D.

2 hours ago, Thomas Börjesson said:

Same here and now P3D shuts down during the startprocess.

This isn't FSUIPC4 then. You need to check why that's occurring. It's no use saying it here with no information whatsoever.

Pete

 

[robvanderwiele]

Thanks for your reply Pete. Now I know it isn't a problem, thanks. The reason for me doing a complete re-install was to start fresh again. I'm not doing that with every update but it was time again for that.

Regards,

Rob