Jump to content
The simFlight Network Forums

PMDG 777 AUTOPILOT


Recommended Posts

Hi.. I disabled all controls in my FSX by pressing CTRL+K. I configured FSUIPC accordingly in axis assignments, key presses. I am also using EZDOK. So I loaded my PMDG test flight. I was at FL410. So when I went to the aircraft view in ezdok, i am only moving my POV 1 in my logitech xtreme 3d and I notice that my autopilot keeps on disconnecting. 

 

So the next what I did was I kept my joystick aside and enabled view with mouse(MOV) button. And in this case the joystick did not come into play and my button to disconnect AP is Z. Still after a few seconds my AP disconnects. I tried this over 5 times intentionally to find the key which causes the AP to disconnect but I could not find the source key.

 

regards

Jazeera

Edited by JAZEERAXD
Link to comment
Share on other sites

  • 2 weeks later...
On 8/9/2016 at 11:53 PM, JAZEERAXD said:

I disabled all controls in my FSX by pressing CTRL+K. I configured FSUIPC accordingly in axis assignments, key presses. I am also using EZDOK. So I loaded my PMDG test flight. I was at FL410. So when I went to the aircraft view in ezdok, i am only moving my POV 1 in my logitech xtreme 3d and I notice that my autopilot keeps on disconnecting.

Ctrl+K disabled all controls in FS? Really? I didn't know that! (Does that include the "disabled controls" control? :-) )

Use FSUIPC logging. Enable Button/Key and Event logging, then when the AP disconnects check what happened in the log file.

Pete

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.