Button & Switch assignment options

[ErichB]

Hi Peter

After my PFC USB controller fiasco I have just reinstalled P3D (v3.4) and am using 4.995 fsuipc.  The axes I have assigned were using the 'send direct to FSUIPC' option.  Axes assignments are all working fine. 

But I have a problem with my buttons and switches options selection.  I no longer have a 'Flaps Increase' and 'Flaps Decrease' or and 'Elev Trim Up' or Elev Trim Down' option.  I think the options I now have are 'Flaps Position Set' and 'Elevator Trim Set' (or something similar).  The same for 'Gear Up' and 'Gear Dn'  - which are missing from the dropdown options.

I sure this is probably a quick fix but not sure how to get the original dropdown options back.

Cheers

erich

 

 

 

[Pete Dowson]

1 hour ago, ErichB said:

I have just reinstalled P3D (v3.4) and am using 4.995 fsuipc.

If you mean 4.955, then it  doesn't work with P3D3.4. You need 4.956 released two weeks ago, and now 4.957, released today. Please always check for latest versions, especially when you are using a P3D only just released by L-M this week!!!

(And note the specific fix listed "Made controls list scan complete set of Controls in P3D versions 2 &  3 -- previous list was missing some").

Pete

 

[ErichB]

2 hours ago, Pete Dowson said:

If you mean 4.955, then it  doesn't work with P3D3.4. You need 4.956 released two weeks ago, and now 4.957, released today. Please always check for latest versions, especially when you are using a P3D only just released by L-M this week!!!

(And note the specific fix listed "Made controls list scan complete set of Controls in P3D versions 2 &  3 -- previous list was missing some").

Pete

 

 

Great.  Thanks Pete