Reducing trim increment

[hokfujow@gmail.com]

Hi - I'm finding that in MSFS 2020 the elevator trim increments are a bit too large - making it hard to get it just right.  (I don't have this issue in FSX).  I'd like to assign buttons to increase/decrease elevator trim but using a finer increment.  I believe this can be done with parameters in some way but I'm a bit unclear just how to do it.  There's a lot in the user guide - a pointer to what procedure to focus on would be very helpful. 

Thanks

[John Dowson]

On 12/19/2020 at 12:04 AM, hokfujow@gmail.com said:

Hi - I'm finding that in MSFS 2020 the elevator trim increments are a bit too large - making it hard to get it just right.  (I don't have this issue in FSX).  I'd like to assign buttons to increase/decrease elevator trim but using a finer increment.  I believe this can be done with parameters in some way but I'm a bit unclear just how to do it.  There's a lot in the user guide - a pointer to what procedure to focus on would be very helpful. 

Thats interesting as most people find that the increments/decrements are too small and need to increase them! However, the procedure is the same. You can use offset 0x0BC0 with the Offset Sword Increment/decrement controls to specify the granularity you require, as explained in this post: 

John

 

 

[hokfujow@gmail.com]

Thank you so much!