offset for rudder and aileron trim

[Bob Spinner]

I have searched all the documentation that downloads with versions 4. 5, 6 and 7 of FSUIPC but nowhere can I find the offsets for the rudder and aileron trims. The offset for elevator trim and in conjunction with 'trim set' works a treat. Without the offsets for the rudder and aileron trims the 'trim set' command works just once and that's it. I am in no way a programmer but I am a bit of a dinosaur and so any help in simple English would be very much appreciated.

Stay safe

Bob

[John Dowson]

Ho Bob,

First, you posted in the User Contributions sub-forum, where it explicitly states (in simple English!) NOT for Support Requests. Please take care to post in the correct forum for support (here or the FSUIPC7 sub-forum).

The document you are looking for is the FSUIPC Offset Status document:

0480	8	Aileron trim axis input, 64-bit floating point (double), read-only	?-Intl	N/A
0488	8	Rudder trim axis input, 64-bit floating point (double), read-only	?-Intl	N/A

0490	8	Aileron trim axis required value, 64-bit floating point (double). If 2^0 is set in the byte at 04A0, then, when written, this value is copied to the FS trim (2EB0) instead of the value in 0480	N/A	?-Intl
0498	8	Rudder trim axis required value, 64-bit floating point (double). If 2^1 is set in the byte at 04A0, then, when written, this value is copied to the FS trim (2EC0) instead of the value in 0488	N/A	?-Intl

 

Cheers,

John

[Bob Spinner]

First , thanks for such a speedy reply, if only everything in life could be as good. Secondly, my apologies for not posting in the correct place. Just so I don't get it wrong in the future where should it have been?

Bob

[John Dowson]

9 minutes ago, Bob Spin said:

where should it have been?

Here - in the main support forum (I moved your post for you).
The FSUIPC7 / MSFS sub-forum is specifically for FSUIPC7, all other support requests should go here.
The 'User Contributions' forum is for contributions (advice, scripts, etc) from users, not support requests.

[Bob Spinner]

Thanks John