FSUIPC 6 for P3Dv4 w/ GoFlight Modules

[bubbapat]

I have just purchased FSUIPC6 and I'm running P3Dv4.  I have about 15 Goflight Modules and I cannot get FSUIPC to recognize and button or switch commands. 

Does anyone know if GoFlight modules are not programmable through FSUIPC?  I can't get through tp GoFlight technical department as it says the number is no longer in service.

Any help would be greatly appreciated.

[John Dowson]

Did you install the GoFlight driver, GFDev64.dll, into your FSUIPC6 folder? If not, please do that - its available from www.fsuipc.com.

[bubbapat]

Thank you so much. I will try that right now.

[bubbapat]

I tried but no difference. The only FSUIPC folder I found was in the Documents tab under FSUIPC. Is that the correct folder?  I am new at this so forgive my ignorance if that's incorrect.

 

[John Dowson]

7 hours ago, bubbapat said:

I tried but no difference. The only FSUIPC folder I found was in the Documents tab under FSUIPC. Is that the correct folder?  I am new at this so forgive my ignorance if that's incorrect.

No, that's most probably where your documents are installed. Now you have found that, you can try reading some of it - you should at least read the Installation and Registration guide, which will explain where things are installed. You should also take a look at the User Guide.

The installation folder is the folder you selected (or accepted) as the folder to install FSUIPC into. If you do nor know where this is, use the 'Open Folder' button in the FSUIPC Logging tab. The dll needs to go into that folder.

John

[bubbapat]

Thanks John, I found it and now FSUIPC recognizes my GoFlight modules. Thank for your help and direction!