How to reverse an FSUIPC Axis?

[toby23]

I would like to assign Left and Right brake to a single axis on my Virpil Mongoos T-50 CM2Joystick so that I can brake correctly in the Spitfire.

The assignment works but the axis are reversed so holding the brake lever releases them, instead of the other way round.

Q. How can I reverse the axis in FSUIPC? 

NB If I assign this axis in MSFS, it is not recognised correctly and acts as a button even though it is shown as an axis.

Thank you,

Toby

[toby23]

I figured this out. I needed to tick 'REV' in the calibration options.

 

[John Dowson]

👍

Note that you should always calibrate any axis assigned with 'Send direct to FSUIPC Calibration'.
For axis controls that don't go via FSUIPC calibration, you can use the scaling facility instead, documented in the Advanced user guide (P41).

John