FSUIPC6 not responding automatically

[Pluto7777]

Sorry i had posted my question in the wrong sub d, so i pose again here:  with FSLabs/P3D , my commands are not working, i always have to open FSUIPC window and tap at the bottom: reload all axis, and after this, things works as they should; Do i have to add a cfg line somewhere ?

 

[John Dowson]

2 hours ago, Pluto7777 said:

Sorry i had posted my question in the wrong sub d

?

2 hours ago, Pluto7777 said:

with FSLabs/P3D , my commands are not working, i always have to open FSUIPC window and tap at the bottom: reload all axis, and after this, things works as they should; Do i have to add a cfg line somewhere ?

Sorry, but it is not clear to me what your issue is with this description - can you please elaborate. For example, I do not know what "tap at the bottom" means.

It would also help if you could attach your FSUIPC5/6.ini and FSUI{C5/6.log files, the latter generated with Axis controls logging enabled (if your issue is with axes assignments) and when you experience (and rectify) the issue.

John

[Pluto7777]

John, it s not a big issue as all of my TCA levers and buttons are working OK, but not before i do this additional sequence: open FSUIPC window, go to axis assignment and at the bottom: reload all assignments, then i am ready to go, it takes 3 seconds, so no big deal, but i guess my memorized assignments should start automatically...

[John Dowson]

6 hours ago, Pluto7777 said:

i guess my memorized assignments should start automatically...

Yes, they should. Not sure what is causing this - can you check the Power Management settings on your usb hubs (using Device Manager) and make sure that Allow the computer to turn off this device is unchecked.

This has been reported previously for FSUIPC7, and I added an extra ini paramater which when set will automatically perform an axis scan when a simconnect connection is established. I can look into adding this ini parameter to FSUIPC6 to see if that helps, but this will be sometime next week.

John

 

[Pluto7777]

Allow computer....  is indeed unchecked, so yes i am interested in that extra ini parameter to add in my FSUIPC6.   Not urgent... it works fine with that reload button for now.

[John Dowson]

Can you try the attached dll to see if this helps - add the following to the [General] section of your FSUIPC6.ini file:
    AxisScanOnStart=Yes

Let me know if it makes any difference. if not, can you show me your FSUIPC6.log and FSUIPC6.ini files. 

John

FSUIPC6.dll